Legislation
Search statutes
Full-text search across the Laws of Uganda. Use the Chapter filter below to narrow to one Act.
-
Weights and Measures (Testing and Stamping) Fees Rules > Rule 11: The Weights and Measures (Testing and Stamping) Fees Revoac* of S.L J* Rules, 1985 and the Weights and Measures (Testing and …
-
Weights and Measures (Testing and Stamping Fees) Rules > Rule 1: Title These Rules may be cited as the Weights and Measures (Testing and Stamping Fees) Rules, 2017.
-
Weights and Measures Act > Part IV - Weighing and measuring for trade > Section 22: Rules relating to weighing or measuring and fees The Minister may make rules with respect to (a) general specificat…
-
Weights and Measures Act > Part IV - Weighing and measuring for trade > Section 17: Examination, stamping and adjusting of equipment by inspector and certificate of verification (1) An inspector sh…
-
Weights and Measures (Repair of Weighing and Measuring Equipment) Rules > Part IV - DIXT.ARA'IIOX BY APPUCAXT > Rule 90: Calibration chart (1) All tanks shall after calibration be accompanied by a ca…
-
…plied to the consumer within the accuracy limits of the meter prescribed in the Weights and Measures (Electricity Meters) Rules, 2015. (2) A holder of a distribution licence shall ensure that all meters installed at consumer premises are…
-
…e of Quality of Service) Regulations, 2020 > Part VIII - T-METERS > Section 34: Testing of installed electricity meters (1) A holder of a distribution licence shall conduct a periodic inspection and testing of electricity meters in…
-
…ent) Act, 2008 > Part III - AMENDMENT OF FINANCE ACT, > Section 1: Registration fees on new registration Vehicles for transport of persons, hearses Sedan cars, saloon cars estate cars excluding dual (a) 750,000 …
-
…020 > Part 2 - Categories of waste requiring special consideration > Section 2: Testing methods (1) Polishing a test metal chip of 10 cm. long, 1 cm. wide and 1 cm. thick, which is specified in JISG 3101 (1987) with the polishing paper…
-
. (6) A manufacturer may use any measurement procedure approved by the Commission to prepare data demonstrating the compliance of the equipment. (7) Any information relating to measurement…